Kodama Forum

Problems setting up Ideamaker for the Trinus

Talk about Pango, Simplify3D, Cura, and all else.
DarkbutGood
Posts: 1

Fri Dec 01, 2017 8:20 pm  

I am having trouble setting Ideamaker to make quality prints on the Trinus. I think that the printer profile is fine, rather the problem is in the slicer template.

What slicer template settings would you recommend for 0.05mm 0.1mm and 0.2mm layer hight?

Thank you for your help.

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest