Kodama Forum

Print stops after 1-2 layers

Kodama will consolidate FAQ and answers (from Kodama + contributors/users) in this forum.
zmajoshi
Posts: 5

Wed Nov 08, 2017 3:48 pm  

Hi I have a strange problem,after i replaced hotend printer started to act strange.
Printer starts printing but after first/second layer it finishes by just positioning printing head in corner and that's it.
Did you have issues like this?

User avatar
thomas
Posts: 187
Location: close to Zürich / Switzerland

Wed Nov 22, 2017 12:47 pm  

You've a LCD-display? If so, check nozzle temperature, if not, connect to a PC/Mac and verify via PANGO-console the temperatures. Sounds like a temperature drop due to broken cable for nozzle or HBP or a bad connection of the plug of either of these heaters.
backer # 2040

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest