Kodama Forum

Aluminium filament fail to launch.

What kinds of filament are you using? Where did you get it? What are your results?
Sno8oy
Posts: 3

Fri Mar 03, 2017 11:07 pm  

Hi all, new to printing and have been making a few prints with the PLA no problems but when I tried the aluminium PLA it would not extrud. I was using the same setup .1 layer, 30/sec, 200oC. Any help greatly appreciated.

User avatar
Afro3dprinter
Posts: 160

Sat Mar 04, 2017 1:15 pm  

Hm On the Trinus it should be flowing like butter at 200, try 215? if no joy maybe your nozzle is blocked..

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest