Kodama Forum

Aluminum Print problem

What kinds of filament are you using? Where did you get it? What are your results?
jaymcd
Posts: 56

Wed Mar 15, 2017 6:44 am  

Hi,

I printed a design that my son made in Sketchup. you can really see the layers in the print and in a couple of spots it looks like it skipped or missed filling in . At the rear of the print there is a warped / raised section.

Printed on non heated bed with Aluminum PLA at 200 degrees.

Not sure what the problem is? Any ideas?

Thanks
Jay
IMG_1044.JPG
IMG_1045.JPG

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest