Kodama Forum

Printing TPE

What kinds of filament are you using? Where did you get it? What are your results?
Valquirio
Posts: 1

Sat Mar 18, 2017 5:25 pm  

I just failed to load some Maker Geeks TPE flexible filament in my Trinus extruder. Upon taking the extruder cover off it became clear that the filament had buckled and curled between the drive gear and the entrance to the hot end feed tube. There is more of a gap between the gear and the tube than I would expect. Has anyone encountered this before? Does anyone have a sugested work around?

Thank you,
Val

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest