Kodama Forum

Polysmooth Settings?

What kinds of filament are you using? Where did you get it? What are your results?
Tipster
Posts: 26

Fri Mar 24, 2017 4:35 am  

Hey all, I just got my polysmooth shipment and went off to start printing. My first couple models are nowhere near the quality I had before, and I was wondering if anyone has any recommended settings/tweaks for this particular filament?

Tipster
Posts: 26

Mon Mar 27, 2017 10:59 pm  

An update to clarify. These are the kind of results I'm getting when I try to print with polysmooth (this particular print failed near the end, but you can see the various flaws all over that show up in other prints as well).
I have tried both Cura 2.5 and Simplify3d and each has similar flaws.

polysmooth.JPG

Tipster
Posts: 26

Tue Mar 28, 2017 6:24 am  

I think maybe I've solved this by tweaking my retraction settings. Now I just need to figure out how to get my raft to start sticking again. :|

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests