Kodama Forum

Trouble Printing With Nylon

What kinds of filament are you using? Where did you get it? What are your results?
alleybeachelectric
Posts: 3

Sat Jun 24, 2017 3:46 am  

Hello,
I'm Trying to print with Nylon, specifically Taulman Bridge, and It's having a really difficult time sticking to the plate.
I'm using the Tak sheet that I ordered with, have the extruder set to 250C, bed at 70C, and its still not working :/
Anybody else have problems with it?
Thanks! :D

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 3 guests