Kodama Forum

adjusting the z axis / bed height

For problems or confusion with your Trinus kit.
jsprenkle
Posts: 30

Sat Jan 21, 2017 5:42 pm  

Good morning,
I'm trying to use the printinz bed plate with the trinus.
I was hoping to cure the 'change the bed plate cover AGAIN?' blues.
The problem is it's thick:
DSC00574.JPG


What's the best way to adjust the bed plate further from the extruder nozzle?

vinceg3
Posts: 58

Sun Jan 22, 2017 12:15 am  

Pango console
Or simplify 3d in expert settings.
Really good explained on their website.

murfmv
Posts: 12
Location: Massachusetts

Mon Jan 23, 2017 1:01 am  

Use your Z axis offset to adjustnozzle height. Make sure a piece of computer printer paper can fit in between nozzle and bed.

Fred

User avatar
svfugu
Posts: 30

Thu May 18, 2017 6:02 pm  

When you guys say to make sure the paper fits under the nozzle, how tight/loose a fit are we going for?
Some rubbing, but easy movement, or virtually no contact at all or what?

murfmv
Posts: 12
Location: Massachusetts

Thu May 18, 2017 7:58 pm  

Snug but moveable Others say two sheets of paper

3dnewbies
Posts: 1

Fri Jul 14, 2017 8:40 pm  

As a newbie are there any tips on how you adjust the nozzle so it isn't too close to the print bed? I'm using Pango and Mac( I'm not able to connect via USB). Not sure what the perfect height should be. Is it just trial and error and entering different heights and giving it a go? Thanks

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest