Kodama Forum

Trinus wont turn on

For problems or confusion with your Trinus kit.
Posts: 1

Mon Dec 04, 2017 10:45 pm  

I set a print to go last night and when i went to check it today i saw it only completed the first hours work. I unplugged the computer connection and saw that that was the only thing powering it as the normal power supply was not doing anything. I tried removing the switch, plug in at a different outlet in a different room but nothing... my printer has lost the ability to power up. Is it the actual printer, the power lead?

User avatar
Posts: 383
Location: Japan

Tue Dec 05, 2017 8:19 am  

Probably the power supply unit (PSU) since USB 5 volts is apparently powering logic circuits. Suggest you measure output of PSU with a multimeter to see if 12VDC is coming out as expected. Take a photo of the multimeter test and send it to support@kodama3d.com for help troubleshoot. If your PSU is dead it will be covered by warranty.
Roi Igarashi, Chiba, Japan.

  •   Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest